AL-KO manufacturer a wide range of trailer hubs and can accommodate just about any wheel drilling pattern.
All of AL-KO’s hubs are manufactured from high grade ductile iron to give maximum achievable strength.
Some of AL-KO’s hubs are available in zinc plated or hot dipped galvanised finish as well as the traditional raw cast finish.
The capacity of a hub is dependent on the size of wheel bearings fitted and such dimensional limits such as flange diameter and the available hole in the wheel to which it is fitted (on the hub this is the hub outer boss dimension).
To ascertain what hub from the vast AL-KO range is required it is important to know the following:
– Total load you expect a pair of hubs to carry in kg.
– Wheel bearing type to be fitted (LM, slimline, 1.5 t, etc)
– Wheel drilling pattern (HQ Holden, 5 stud Ford, 6 stud Landcruiser).
This information is usually enough to specify the hub you need.
AL-KO can supply hubs from studded only through to hubs complete with studs, wheel nuts, bearings, grease seals and caps supplied